Call us
+1 (888) 658-5774
conTROL
The EMC operating enclosure
IP 66, Optional: IP 67
The key product features:
• Enclosure material: diecast aluminium
• Enclosure surface: powder coating, RAL 7032
• High inner collar
• Tooth system in the bottom section for continuous contact
• Cover with high protective collar
• Sizes compatible with standard enclosures available on the market, therefore easy to exchange
• Lid screws in stainless steel 1.4567
• Enclosure seal: TPE molded gasket
Request offer
PDF datasheet
More
conTROL is a robust and versatile range of RFI/EMI shielded aluminum enclosures which is ideal for machine control equipment. The enclosures feature in-built shielding that does not require expensive and delicate conductive gaskets. Continuous contact is created by means of a patented tooth system pre-cast into the lid and base.
Standard features include a deep recessed lid which is designed to protect buttons and control switches. The enclosures are water-tight and weather resistant to IP 66. Threaded screw bosses are provided inside for fitting circuit boards, mounting plates, terminal rails etc. Accessories such as mounting plates and cable glands are also available.
We can supply conTROL enclosures fully customized to your requirements.
Product overview
Dimensions
Data Sheets
Data
- conTROL
- EKT 082
- Part No.
- 310.082.000
- Dimensions
- 3.35x5.12x3.07 Remember
- conTROL
- EKT 083
- Part No.
- 310.083.000
- Dimensions
- 3.35x7.09x3.07 Remember
- conTROL
- EKTF 082
- Part No.
- 311.082.000
- Dimensions
- 3.35x5.12x2.17 Remember
- conTROL
- EKTF 083
- Part No.
- 311.083.000
- Dimensions
- 3.35x7.09x2.17 Remember
5.12x3.35x3.07
7.09x3.35x3.07
5.12x3.35x2.17
7.09x3.35x2.17
| Enclosure sizes | 4 |
| Additional info | High shielding from radiation interference (RFI/EMI tested by the University of Hanover) Collar protects command and information buttons |
| Inexpensive, as there is no need for expensive conductive gaskets Large range of accessories | |
| Enclosure | Diecast aluminum alloy |
| EN AN-44300 DIN EN 1706 | |
| (GD Al Si 12/DIN 1725) | |
| 1° mold slope for casting ejection > internal circumference dimensions decrease by 1° towards enclosure bottom. | |
| Fastening | Separate screw channels outside of the enclosure interior |
| Console panel integration with installation kit | |
| Internal mounting | M4 fastening thread in lateral bars on the enclosure base and optional fastening on the lid |
| Ingress protection | IP 66 / EN 60529 |
| Optional: IP 67 / NEMA 4 | |
| Gasket | TPE molded gasket, silicone-free |
| Optional: Silicone gasket | |
| Lid screws | Stainless steel 1.4567, captive |
| Surface | Powder coating RAL 7032, silky gray |
| Optional: Special colors | |
| Optional: Corrosion protection | |
| Customizing | Learn more about our full customizing service for installation-ready enclosures |